08. Each side of the gas tank was installed and plumbed. 09. Tony installed the rear wheel into the frame and checked for proper spacing and rear caliper fitment.09. Tony installed the rear wheel into the frame and checked for proper spacing and rear 10. The custom rear brake bracket and four-piston caliper from Performance Machine will make sure this bike stops under any circumstance.10. The custom rear brake bracket and four-piston caliper from Performance Machine will m 11. Kody installed and wired the rear tombstone taillight and Autogem turn signal/license plate lights.11. Kody installed and wired the rear tombstone taillight and Autogem turn signal/license 12. Tony installed and wired the classic fender tip lamp giving the front of this bike a real retro feel.12. Tony installed and wired the classic fender tip lamp giving the front of this bike a 13. More Autogem lights were installed under the pogo seat, and all the wiring was hooked to the battery.13. More Autogem lights were installed under the pogo seat, and all the wiring was hooked 14. The cat-eye dash was installed over the gauge cluster and was bolted into place. The bike was then fired up concluding the build.14. The cat-eye dash was installed over the gauge cluster and was bolted into place. The 15. Here’s a sneak peek at the NMM Giveaway Bike. Don’t worry, we will be showing you a complete feature on the bike next month, so stay tuned!15. Here’s a sneak peek at the NMM Giveaway Bike. Don’t worry, we will be showing you a c Source: J&P Cycles (888) 994-7677 | www.jpcycles.com National Motorcycle Museum (314) 462-3925 | www.nationalmcmuseum.org « | 1 | 2 | View Full Article By Jeff G. Holt Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
