7. Here is a shot of the control panel starting with the three indicator lamps, power, welding current, and the Thermo switch (A). This is the slope down or spot time (B). This is the final current knob that can be adjusted from 10 to 90 percent of the base current (C). This is the post gas flow adjustment (D). This is the welding mode switch; with five settings four for TIG (based on materials) and one for stick welding (E). This is the amperage adjustment knob (F). Here is the remote/local switch this is to work the foot pedal or the torch to control amperage (G). Here is the Lift Arc/HF switch, this lets you choose between bringing the Tungsten in contact with the weld Arc or trigger start the arc with the pedal (H). If you chose to you can use and adjust the pulse TIG welding by turning this knob, or in the off position this can be done with the foot pedal (I).