4. The six base plate tangs were bent outward slightly at the same angle as the pressure plate, then the base plate was inserted inside the clutch spring.4. The six base plate tangs were bent outward slightly at the same angle as the pressure 5. After installing the VPC unit, we tightened the bolts to 100-inch pounds with a torque wrench.5. After installing the VPC unit, we tightened the bolts to 100-inch pounds with a torque 6. A new gasket was installed, and then we adjusted the clutch cable to 1/8-inch of free play at the lever pivot.6. A new gasket was installed, and then we adjusted the clutch cable to 1/8-inch of free 7. Finally, the derby cover bolts were tightened to 90-inch pounds with a torque wrench.7. Finally, the derby cover bolts were tightened to 90-inch pounds with a torque wrench. SOURCES Advanced Innovation Machinery « | 1 | 2 | View Full Article By Jeff G. Holt Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
