You could say that this is really the story of three bikes, not just the one in the photos. It began a couple of years back when Carolina Harley-Davidson created an Arlen Ness Y2K scoot for Morri Irvin. He fell in love with the rubber-mount bike, but as often happens with a great motorcycle, someone made him an offer he couldn't refuse. After the check cleared, Morri found himself with a pile of money but no ride.
This brings us to motorcycle number two. Morri again showed up at Carolina H-D in Gastonia, NC, to replace his beloved Y2K. This go-'round, however, he wanted to try a different rubber-mount chassis. After talking it over with Carolina Harley's Jim Bortles, Morri went with a brand-new (at the time) Dyna Low Rider. Plans were made, and the bike went straight into the shop area like a caterpillar into a cocoon.
It emerged eight months later as bike number three (depending on how you count): this orange beauty. Jim put so much work into Morri's ride that it's only barely a Harley and nowhere near a stocker.
That's because Morri wanted something closer to his Y2K than a Dyna. On Jim's recommendation, Irvin gave the go-ahead to cut and reweld the frame with the neck at 41 degrees and 6 more inches stretch outward for length; that set the tone for a longer bike. Jim also widened out the back with a new swingarm and 240mm rear tire like the fat rubber on the other ride. New frame work wasn't the only stylistic nod to Morri's old ride, though. More than a few Ness parts were swapped onto this motorcycle, most notably the primary, wheels, back fender, and gas tank.
Insofar as the motor work goes...well, the cases are still Harley. You can't really say that for the rest, though. Part of what Morri loved about his last bike was the combo of a 116-inch motor set in a rubber-mount frame that insulated him from vibration. He absolutely had to have the same feel with this bike. Buddy Cook took care of that by stripping the Twin Cam down to the cases and re-creating it from the bottom up, using JIMS Twin Cam flywheels, rods, pistons, and cylinders to bump up the displacement on a platform that could handle the additional wear and tear. It's topped off by Screamin' Eagle heads and valves as well as JIMS rockers with Pro-One boxes.